Komatsu — Dumping Procedure

Operating Instructions - Section 30 OM3058 Page 30-16 HOIST SYSTEM Sometimes it is necessary to dump a load from the body of a truck when the hoist system is inoperable. To use this feature, two hoses (supply and return) must be connected to a hydraulic source (such as an operational truck or an auxiliary power unit). Hookup Ensure there is an adequate, clear area to dump the loaded box. When the good truck is in position, stop the engine and wait two minutes to allow the hydrau- lic system to bleed down. Ensure hydraulic pressure has bled off before connecting hoses.

Quick disconnect fittings (1 & 2, Figure 30-2) are pro- vided on the overcenter valve to allow operation of the hoist circuit for temporary truck operation if the hoist pump, hoist valve or other hoist system compo- nent is not operational. This will allow maintenance personnel to raise the truck body to dump the load before moving the disabled truck. 1. With the good truck parked as close as possible to the disabled truck, attach a hose from the power up quick disconnect (1, Figure 30-2) to the power down circuit of the disabled truck. (Hose must be rated to withstand 17 237 kPa (2,500 psi) or greater pressure. In the example, Figure 30-2 illustrates a typical hookup from the good truck.

The disabled truck may be another Model 830E, or a different Komatsu elec- tric drive truck model. NOTE: The power down circuit will use a smaller diameter hose (tube) than the power up circuit. 2. Connect another hose from the power down quick disconnect (2) to the power up circuit of the disabled truck. The hoist circuit relief valves are adjusted to 17 240 kPa (2,500 psi). NOTE: If both trucks are a Model 830E, the hoses will be installed at the quick disconnects shown in Figure 30-2 and will be crossed when connected. Dumping Procedure Raising the Body: 3.

On the disabled truck, move the hoist control lever to power up and then release it to place the hoist pilot valve in the HOLD position (leave in this position during entire procedure). 4. Start the engine on the good truck, place the hoist control in the power down position and increase engine RPM to high idle to dump the disabled truck. If the body of the disabled truck fails to raise, increase the good truck power down relief pressure as follows: a. Stop the engine and wait two minutes to allow the hydraulic system pressure to bleed down. b. Remove the cap from the hoist pilot valve relief valve located in the hydraulics compo- nents cabinet behind the cab.

While counting the number of turns, slowly screw the relief valve adjustment screw clockwise until it bot- toms. FIGURE 30-2. HOIST CONNECTIONS 1. Power Up Quick Disconnect 2. Power Down Quick Disconnect 3. Over Center Valve 5. Repeat Step 4 to dump the disabled truck. NOTE: The matching quick disconnect couplings for items (1 & 2) is PB4684.