Komatsu — TOWING

OM3058 Operating Instructions - Section 30 Page 30-17 Lowering the Body: 6. Place the hoist lever of the good truck in FLOAT to lower the body. If necessary, momentarily place the hoist control in POWER UP until the body is able to descend in FLOAT. Do not accel- erate the engine. A disabled machine may be towed after the following minimum precautions have been taken. 1. Shut the engine off. 2. If equipped, install hydraulic connections for steering and dumping between the tow vehicle the and disabled vehicle. Check the disabled vehicle braking and steering systems for normal operation. 7. After body is lowered, stop the engine and wait two minutes to allow the hydraulic system to bleeddown.

Then disconnect the hoses. 8. Reduce power down relief valve pressure to normal on good truck by turning the adjustment counterclockwise the same number of turns as required in step 4 b. 3. If the disabled truck is loaded, dump the entire load. Never pull or tow a loaded truck. 4. Inspect the tow bar for adequacy. The bar must be approximately 1.5 times the gross vehicle weight of the truck being towed. 9. Check power down relief pressure using instructions in Section L10. 5. Ensure the tow vehicle has adequate capacity to both move and stop the disabled truck under all conditions. 10. Check hydraulic tank oil level. 6. Block the disabled truck to prevent movement while attaching tow bar. 7.

Release the disabled truck brakes and remove the blocking. TOWING 8. Sudden movement may cause tow bar failure. Smooth, gradual truck movement is preferred. Prior to towing a truck, many factors must be care- fully considered. Serious personal injury and/or sig- nificant property damage may result if important safety practices, procedures and preparation for moving heavy equipment are not observed. DO NOT tow the truck any faster than 8 kph (5 mph). 9. Minimize tow angle at all times - never exceed 30°. The disabled truck must be steered in the direction of the tow bar.