Komatsu — Rest Switch

OM3242 Operator Cab And Controls - Section 32 Page 32-15 Key Switch Key switch (1, Figure 32-7) is a three-position (OFF, RUN, START) switch. Rotating Beacon Light Switch (Optional) Switch (2, Figure 32-7) controls the operation of the rotating bea- con light. Heated Mirror Switch (Optional) Switch (3, Figure 32-7) controls the operation of the heated mir- rors. Rest Switch Switch (4, Figure 32-7) is a rocker type switch with a locking device for the OFF (lower side pressed in) position. There is no LED light to illuminate when this switch is in the OFF position. A small red tab must be pushed up to unlock the switch before the top side can be depressed to the rest position.

When in the rest (ON) position, an internal amber lamp will illuminate. The switch must be activated to de-energize the AC drive system whenever the engine is to be turned off or parked for a length of time with the engine running. Starting When the switch is rotated one position clockwise, it is in the RUN position and all electrical circuits except START are activated. 1. With the selector switch in PARK, rotate key switch fully clockwise to the START position, and hold this position until the engine starts. The START position is spring-loaded to return to RUN when the key is released.

If the engine is equipped with a prelube system, a noticeable delay will occur before engine cranking begins. The selector switch must be in PARK and the vehicle not moving to enable this function. This will allow the engine to continue running while the AC drive system is de-energized. 2. After engine has started, place rest switch (4, Figure 32-7) in the OFF position, which will de- activate the rest mode of operation. Refer to the discussion of rest switch later in this chapter. NOTE: The electric cranking motors have a 30 sec- ond time limit. If the 30 second limit is reached, cranking will be prohibited for two minutes. After two minutes, cranking will be allowed.

If the 30 second limit is reached seven consecutive times, the key switch must be turned to the OFF position. This will allow the interface module to power down and reset, which requires seven minutes to complete. Activation of the rest switch alone DOES NOT completely ensure that the drive system is safe to work on. Refer to Section 20, Safety, for more information on servicing a 830E truck. Check all "link-on", or "link energized", indicator lights to verify the AC drive system is de-engergized before performing any maintenance on the drive system. DO NOT activate the rest switch while the truck is moving! The truck may unintention- ally enter the “rest” mode after stopping.

An amber (yellow) indicator light in the overhead panel (B6, Figure 32-8) will illuminate when the "rest" state has been requested and entered.