Komatsu — Tachometer

Operator Cab And Controls - Section 32 OM3242 Page 32-16 Switch (5, Figure 32-7) must be used when the engine is running during dumping and loading operations only. The brake lock switch actuates the hydraulic brake system which locks the rear wheel service brakes only . When pulling into the shovel or dump area, stop the truck using the foot-operated service brake pedal. When the truck is completely stopped and in the loading position, apply the brake lock by pressing on the top of the rocker switch. Move the directional control lever to NEUTRAL. DO NOT place the control lever in PARK. To release, press the lower part of the rocker switch.

Wheel Brake Lock Control Cab/Air Conditioner Vents Vents (7, Figure 32-7) may be directed by the opera- tor to provide the most comfortable cabin air flow. Engine Oil Pressure Gauge Gauge (8, Figure 32-7) indicates pres- sure in the engine lubrication system in pounds per square inch (psi). Normal operating pressure after engine warm up must be: Idle - 138 kPa (20 psi) Minimum Rated Speed - 310 - 483 kPa (45 to 70 psi) DO NOT use this switch to stop the truck unless the foot-operated treadle valve is inoperative. Use of this switch applies rear service brakes at a reduced, unmodulated pressure. DO NOT use the brake lock for parking.

With the engine stopped, hydraulic pressure will bleed down, allowing the brakes to release. Right Turn Signal Indicator Indicator (9, Figure 32-7) illuminates to indicate that the right turn signals are operating when the turn sig- nal lever on the steering column is moved upward. Moving the lever to its center position will turn the indicator off. Use at shovel and dump only to hold the truck in position. Tachometer NOTE: The wheel brake lock will not apply when the directional control lever is placed in the PARK position, or when the key switch is OFF, or when the engine is not running. Tachometer (10, Figure 32-7) displays engine crank- shaft speed in revolutions per minute (rpm).

Governed rpm Low Idle - 750 rpm High Idle - 1910 rpm Full Load - 1900 rpm Hazard Warning Lights Switch (6, Figure 32-7) flashes all the turn signal lights. Pressing the top side of the rocker switch acti- vates these lights. When these lights are on, a red LED light will be illuminated inside the switch. Press- ing on the lower side of the rocker switch turns these lights off, and a green LED light will be illuminated.