Komatsu — Ladder Light Switch

OM3242 Operator Cab And Controls - Section 32 Page 32-17 High Beam Indicator Indicator (11, Figure 32-7) illuminates to indicate that the truck headlights are on high beam. To switch the headlights to high beam, push the turn indicator lever away from the steering wheel. For low beam, pull the lever toward the steering wheel. Lamp Test Switch Switch (15, Figure 32-7) is pro- vided to allow the operator to test the indicator lamps prior to starting the engine. To test the lamps and the warning horn, turn key switch (1, Figure 32-7) to the RUN posi- tion and press the top side of the rocker switch for the CHECK posi- tion.

All lamps must illuminate except those which are for optional equipment that may not be installed. The warning horn must also sound. Any lamp bulbs which do not illuminate must be replaced before operating the truck. Releasing the spring-loaded switch will allow the switch to return to the OFF position. A green LED will illuminate in both switch positions. Speedometer/Payload Meter Display Speedometer/payload meter display (12, Figure 32- 7) indicates the truck speed in kilometers per hour (kph) or in miles per hour (mph). The display also shows payload meter information. For more informa- tion, see Section 60, Payload Meter III, in this man- ual. NOTE:

Do not use the lamp check switch while the engine is on. Pressing this switch while the engine is on will cause false electrical system faults. Warning light (D5, Figure 32-8) will illuminate and engine shutdown is required to turn it off. Left Turn Signal Indicator Indicator (13, Figure 32-7) illuminates to indicate that the left turn signals are operating when the turn sig- nal lever on the steering column is moved downward. Moving the lever to its center position will turn the indicator off. Light Switch The instrument panel lights, clear- ance lights, and the headlights are controlled by this three-position rocker type switch (16, Figure 32- 7).

OFF is selected by pressing the bottom of the switch. Press the top of the switch until it reaches the first detent to select the panel lights, clearance lights and tail lights only. Press the top of the switch again until it reaches the second detent to select head- lights, panel lights, clearance lights and tail lights. Water Temperature Gauge Gauge (14, Figure 32-7) indicates the temperature of the coolant in the engine cooling system. The tempera- ture range after engine warm-up and truck operating under normal condi- tions must be: 85°-97°C (185°-207°F) Ladder Light Switch Ladder light switch (17, Figure 32-7) turns the ladder lights on or off.

Pressing the top of the rocker switch turns the lights on. Pressing the bot- tom of the switch turns the lights off. A green LED light will illuminate in both switch positions. Another ladder light switch is mounted at the right front corner of the truck near the base of ladder.