Multiplexed Electrical System Service Manual 12 PM819023/KM815057 (08/14/2012) 12 - 3 DTC Input Received By Item / System Description Detailed Description 8409 CECU Wheel-Based Vehicle Speed Message Wheel based vehicle speed message missing This DTC will be recorded when the control unit does not see the Wheel Based Vehicle Speed message from the engine, or when the message has timed out. Some possible causes for this include faulty wiring to the engine controller, incorrect engine programming or a faulty engine controller. 9003 Chassis Node PTO Oil Temp Open in PTO oil temp circuit This DTC will be recorded when the control unit sees an open at the PTO oil temperature sensor input.
Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 9004 Chassis Node PTO Oil Temp Short in PTO oil temp circuit This DTC will be recorded when the control unit sees a short to ground at the PTO oil temperature sensor input. Some possible causes for this are a pinched wire, water in a connector, or sensor failure. 9109 CECU Accelerator Pedal Position Message Accelerator pedal position message missing This DTC will be recorded when the control unit does not see the Accelerator Pedal Position Speed message from the engine, or when the message has timed out.
Some possible causes for this include faulty data link wiring to the engine controller, incorrect engine programming or a faulty engine controller. 10703 CECU Air Filter Restriction Open in air filter restriction circuit This DTC will be recorded when the control unit sees an open at the air filter restriction sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 10704 CECU Air Filter Restriction Short in air filter restriction circuit This DTC will be recorded when the control unit sees a short to +5V at the air filter restriction sensor input.
Some possible causes for this are a pinched wire, water in a connector, or sensor failure. 11603 CECU Application Air Pressure Open in application air pressure circuit This DTC will be recorded when the control unit sees an open or short to ground at the tractor brake application air pressure sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 11604 CECU Application Air Pressure Short in application air pressure circuit This DTC will be recorded when the control unit sees a short to +5V at the tractor brake application air pressure sensor input.
Some possible causes for this are a pinched wire, water in a connector, or sensor failure. 11703 CECU Primary Air Pressure Open in primary air pressure circuit This DTC will be recorded when the control unit sees an open or short to ground at the primary air pressure sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 11704 CECU Primary Air Pressure Short in primary air pressure circuit This DTC will be recorded when the control unit sees a short to +5V at the primary air pressure sensor input. Some possible causes for this are a pinched wire, water in a connector, or sensor failure.
11803 CECU Secondary Air Pressure Open in secondary air pressure circuit This DTC will be recorded when the control unit sees an open or short to ground at the secondary air pressure sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure.