PACCAR Corporation — Diagnostic Trouble Codes

Multiplexed Electrical System Service Manual 12 PM819023/KM815057 (08/14/2012) 12 - 7 DTC Input Received By Item / System Description Detailed Description 67805 CECU CVSG / MCS Supply CVSG / MCS supply open load This DTC will be recorded when the control unit sees an open load on the power supply to the CVSG bus and the Menu Control Switch. A possible cause of this failure is a broken wire leading to the 2" gauges. A common symptom of this fault is that none of the 2" gauges are working. 67806 CECU CVSG / MCS Supply CVSG / MCS supply shorted to ground This DTC will be recorded when the sees a short to ground on the CVSG supply.

Some possible causes for this are a pinched wire, bent pins on a CVSG or a failed CVSG. 80404 CECU ABS Mode “Tractor ABS Not Installed” input is shorted and ABS system is present. This DTC will be recorded when the control unit “ABS Installed” parameter is disabled and it is receiving messages from an ABS system on V-CAN. If the vehicle is to be equipped with ABS enable the “ABS Installed” parameter. If the vehicle is not to be equipped with ABS remove the ABS control unit. 70104 CECU Electric Over Air Electric over air switch 1 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 1 input.

Some possible causes for this are a pinched wire, water in a connector, or switch failure. 70204 CECU Electric Over Air Electric over air switch 2 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 2 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure. 70304 CECU Electric Over Air Electric over air switch 3 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 3 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure.

70404 CECU Electric Over Air Electric over air switch 4 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 4 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure. 70504 CECU Electric Over Air Electric over air switch 5 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 5 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure.

70604 CECU Electric Over Air Electric over air switch 6 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 6 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure. 70704 CECU Electric Over Air Electric over air switch 7 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 7 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure.

70804 CECU Electric Over Air Electric over air switch 8 short to ground This DTC will be recorded when the control unit sees a short to ground at the electric over air switch 8 input. Some possible causes for this are a pinched wire, water in a connector, or switch failure. 82903 Chassis Node Primary Fuel Open in primary fuel level circuit This DTC will be recorded when the control unit sees an open at the primary fuel level sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure.