PACCAR Corporation — Diagnostic Trouble Codes

12 Multiplexed Electrical System Service Manual 12 - 8 PM819023/KM815057 (08/14/2012) DTC Input Received By Item / System Description Detailed Description 82904 Chassis Node Primary Fuel Short in primary fuel level circuit This DTC will be recorded when the control unit sees a short to ground at the primary fuel level sensor input. Some possible causes for this are a pinched wire, water in a connector, or sensor failure. 83003 Chassis Node Secondary Fuel Open in secondary fuel level circuit This DTC will be recorded when the control unit sees an open at the secondary fuel level sensor input.

Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 83004 Chassis Node Secondary Fuel Short in secondary fuel level circuit This DTC will be recorded when the control unit sees a short to ground at the secondary fuel level sensor input. Some possible causes for this are a pinched wire, water in a connector, or sensor failure. 88609 Adaptive Cruise Control unit cannot read messages from adaptive cruise on V-CAN This DTC will be recorded when the control unit cannot read messages from the Adaptive Cruise ECU.

Some possible causes for this are a broken wire, corroded or disconnected connector, no terminating resistors, no power to the Adaptive Cruise ECU or Adaptive Cruise ECU failure. 91709 CECU High Resolution Vehicle Distance Message High resolution vehicle distance message missing This DTC will be recorded when the control unit does not see the High Resolution Vehicle Distance message from the engine, or when the message has timed out. Some possible causes for this include faulty data bus wiring to the engine controller or a faulty engine controller.

97403 Chassis Node Remote Accelerator Open in remote accelerator circuit This DTC will be recorded when the control unit sees an open at the remote accelerator input. Some possible causes for this are a broken wire, corroded or disconnected connector, or throttle controller failure. 97404 Chassis Node Remote Accelerator Short in remote accelerator circuit This DTC will be recorded when the control unit sees a short to ground at the remote accelerator input. Some possible causes for this are a pinched wire, water in a connector, or throttle controller failure.

102809 CECU Total Engine PTO Fuel Used Message Total engine PTO fuel used message missing This DTC will be recorded when the control unit does not see the Total Engine PTO Fuel Used message from the engine, or when the message has timed out. Some possible causes for this include faulty data bus wiring to the engine controller or a faulty/misconfigured engine controller. 123109 CECU I-CAN Control Unit cannot read messages from cluster on I-CAN This DTC will be recorded when the control unit cannot read messages from the cluster. Some possible causes for this are a broken wire, corroded or disconnected connector, no power to the cluster or cluster failure.

138703 CECU Brake Saver Oil Temp Open in brake saver oil temp circuit This DTC will be recorded when the control unit sees an open at the brake saver oil temperature sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 138704 CECU Brake Saver Oil Temp Short in brake saver oil temp circuit This DTC will be recorded when the control unit sees a short to ground at the brake saver oil temperature sensor input. Some possible causes for this are a pinched wire, water in a connector, or sensor failure.