PACCAR Corporation — Diagnostic Trouble Codes

Multiplexed Electrical System Service Manual 12 PM819023/KM815057 (08/14/2012) 12 - 9 DTC Input Received By Item / System Description Detailed Description 138803 Chassis Node Transfer Case Oil Temp Open in transfer case oil temp circuit This DTC will be recorded when the control unit sees an open at the transfer case oil temperature sensor input. Some possible causes for this are a broken wire, corroded or disconnected connector, or sensor failure. 138804 Chassis Node Transfer Case Oil Temp Short in transfer case oil temp circuit This DTC will be recorded when the control unit sees a short to ground at the transfer case oil temperature sensor input.

Some possible causes for this are a pinched wire, water in a connector, or sensor failure. 148109 CECU V-CAN Control unit cannot read messages from ABS on V-CAN This DTC will be recorded when the control unit cannot read messages from the ABS system. Some possible causes for this are a broken wire, corroded or disconnected connector, no terminating resistors, no power to the ABS system or ABS ECU failure. 148209 CECU V-CAN Control Unit cannot read messages from Transmission on V-CAN This DTC will be recorded when the control unit cannot read messages from the transmission ECU.

Some possible causes for this are a broken wire, corroded or disconnected connector, no terminating resistors, no power to the Transmission or Transmission ECU failure. 148309 CECU V-CAN Control Unit cannot read messages from Engine on V-CAN This DTC will be recorded when the control unit cannot read messages from the engine ECU. Some possible causes for this are a broken wire, corroded or disconnected connector, no terminating resistors, no power to the engine or engine ECU failure. 148702 CECU Dash Light Dimmer Dimmer invalid range This is caused by the Dimmer Up or Dimmer Down wires reporting invalid voltage.

Check the switch and wiring for damage 148703 Open in dash dimmer input circuit This DTC will be recorded when the control unit sees an open at the dash light dimmer control input. Some possible causes for this are a broken wire, corroded or disconnected connector, or dimmer control failure. 148704 Short in dash dimmer input circuit This DTC will be recorded when the control unit sees a short to ground at the dash light dimmer control input. Some possible causes for this are a pinched wire, water in a connector, or dimmer control failure. 148707 Dimmer stuck This is caused by either the Dimmer switch button being stuck Up or Down for 20 seconds.

Check the switch and wiring for damage 149106 Short in dash dimmer output #1 circuit This DTC will be recorded when the sees a short to ground on the #1 dimmer output. Some possible causes for this are a pinched wire, water in a connector, or dimmed component failure. This output controls dimming to the left and right spare backlighting. 149206 Short in dash dimmer output #2 circuit This DTC will be recorded when the sees a short to ground on the #2 dimmer output. Some possible causes for this are a pinched wire, water in a connector, or dimmed component failure. This output controls dimming to much of the instrument illumination and backlighting.