PACCAR Corporation — Diagnostic Trouble Codes

12 Multiplexed Electrical System Service Manual 12 - 10 PM819023/KM815057 (08/14/2012) DTC Input Received By Item / System Description Detailed Description 167502 CECU Starter Motor Cooldown Enforce Starter disabled due to over crank protection This DTC will be recorded when the allowed cranking time has been reached and the starter is disabled. This DTC will go away and the starter will be re-enabled after 15 minutes. 176102 CECU Diesel Exhaust Fluid Diesel exhaust fluid level message error This DTC will be recorded when the control unit receives an invalid range on the diesel exhaust fluid level message from the engine ECU or does not receive the message in a timely manner.

176109 Diesel Exhaust Fluid Diesel exhaust fluid level message error This DTC will be recorded when the control unit receives a Not Available signal on the diesel exhaust fluid level message from the engine ECU or when the message has timed out. Some possible causes for this include faulty wiring to the engine controller or a faulty/misconfigured engine controller. 176119 Diesel Exhaust Fluid Diesel exhaust fluid level message error This DTC will be recorded when the control unit receives an invalid range on the diesel exhaust fluid level message from the engine ECU. Some possible causes for this include faulty wiring to the engine controller or a faulty/misconfigured engine controller.

234801 234803 234805 234806 234813 234831 Chassis Node Exterior Lighting - High Beam Left or right high beam output general error Left or right high beam output short to power Left or right high beam output under current or open circuit Left or right high beam output over current Left or right high beam output general error Left or right high beam output not available This set of DTCs will be recorded when there is a problem with one of the High Beam circuits. This could be caused by failed bulbs, wiring harness issues, or corroded connectors. Left high beam output from Pin 13 of the Chassis Node connector A. Right high beam output from Pin 7 of the Chassis Node connector A.

235001 Chassis Node Exterior Lighting - Low Beam Left or right low beam output general error This set of DTCs will be recorded when there is a problem with one of the Low Beam circuits. This could be caused by failed bulbs, wiring harness issues, or corroded connectors. Left low beam output from Pin 1 of the Chassis Node connector A. Right low beam output from Pin 19 of the Chassis Node connector A. 235003 Left or right low beam output short to power 235005 Left or right low beam output under current or open circuit 235006 Left or right low beam output over current 235013 Left or right low beam output general error 235031 Left or right low beam output not available