SWITCHES Windshield Wipers/Washer Your vehicle is equipped with a two-speed, intermittent windshield wiper system. The windshield wiper system is integrated with the exterior lights so that the low beam headlights will turn on when the windshield wipers turn on. To override this function, turn the headlights on and then off again and the low beams will turn off. A seven-position rotary wiper switch (located on the turn signal lever) operates the windshield wipers and washer. Rotate the end of the turn signal lever to change the wiper mode. ID and Clearance Lights Flash Wiper/Washer 3 The first position after OFF is the intermittent #1 cycle.
The next positions are intermittent #2, #3, and #4. The last two positions are wiper low speed and wiper high speed. To Wash The Windshield Push the rotary wash/wipe knob in (towards steering column), hold for more than 0.8 seconds and then release. Hold the knob in to extend the washing cycle. After the lever is released, the wipers will shut off automatically or resume the wiper’s setting speed. The ignition key must be turned to ON or ACC for the wiper/washer switches to operate. NOTE 3-70