PREVENTIVE MAINTENANCE SCHEDULE 5 5-23 PREVENTIVE MAINTENANCE (PM) INTERVALS SYSTEM COMPONENT MAINTENANCE TASK Recommended PM Interval I A B C D E Air Intake Air intake piping, mounting, and charge air cooler Check the system for broken pipes, leaks, joint integrity, cleanliness, and proper support (shown on page 5-99). X Air cleaner Replace the engine intake air cleaner element (shown on page 5-97). When required by air restriction indicator or required by the engine manufacturers operator manual. Clutch Clutch hydraulic fluid Replace fluid and bleed system. X Clutch release bearing Lubricate.
X Inspect and adjust when necessary (no adjustment required for SOLO type clutches) X Cooling Hoses Check the radiator and heater hoses for leaks. X X Extended Life Coolant (ELC) Check the freeze point (shown on page 5-71). X Check for contamination using test strips (shown on page 5-70). X Replace blank water filter if applicable. X Perform lab analysis (shown on page 5-70). If lab analysis shows coolant is unsuitable for continued use: Flush, drain, and refill (shown on page 5-70). Add ELC Extender (shown on page 5-70). X Flush, drain, and refill with new coolant (shown on page 5-70). X Fan clutch Check for air leaks. (shown on page 5-96).
Check the fan drive bearings (turn the sheave in both directions to check for worn hub bearings). X X Solenoid valve Check the fan drive for proper engagement and disengagement. X X