PACCAR Inc. — Rear Suspension Fasteners

REAR AXLE AND SUSPENSION Rear Suspension Fasteners U-Bolt Torque To maintain the performance of the air suspension, check fastener torque values after the first 2,000 miles (3,218 km) of service and every 60,000 miles (96,000 km) thereafter. NOTE Whenever possible, torque all fasteners on the nut end, not the bolt head. NOTE To ensure an accurate torque reading, use properly maintained and calibrated torque wrenches. Clean the nut and bolt. No dirt, grit, or rust should be present. Torque recommendations apply to fasteners supplied and installed by vehicle manufacture. The values listed in the tables below, are for cadmium plated or phosphate and oil fasteners only.

Rear Suspension Fasteners (Metric & Standard) Do not operate the vehicle if the U-bolts are not properly tightened. Loose U-bolts will cause the axle to not be properly secured to the suspension, which could cause loss of vehicle control and an accident. Loose U-bolts can also cause uneven tire wear and poor alignment. Failure to comply may result in death, personal injury, equipment or property damage. WARNING U-bolts are difficult to tighten unless you have the right equipment. If you cannot tighten them correctly yourself, be sure to have them checked and tightened regularly by an authorized mechanic.

5 5-126 SIZE/TYPE TORQUE * Nm Lb-Ft M16 nylon-insert nuts 163-217 120-160 M20 nylon-insert nuts 352-460 260-340 M20 all-metal lock nuts 427-475 315-350 1/2 in. nut 109-122 80-90 3/4 in. nut 394-462 290-340 1-1/4 in. nut 1,877-2,217 1,380-1,630 * Torque requirements apply to manufacturer proprietary suspensions. All other suspensions must refer and adhere to original manufacturers shop manual.