PACCAR Inc. — Rear Axle Lubrication

REAR AXLE AND SUSPENSION Dana Spicer and Fabco Do not mix lubricants of different grades; although, mixing different brands of the same grade lubricant (meeting MIL L2105C), is acceptable. Lubricants of different grades are not compatible and could damage the axle. CAUTION No initial drain is required on Dana Spicer axles that are factory filled with an Dana Spicer-approved synthetic lubricant. All Vehicles with Dana Spicer and Fabco Axles: See Preventive Maintenance Schedule on page 5-12 . Contact your dealer for approved synthetic lubricant brands. Petroleum-based lubricants must be drained within the first 5,000 miles (8,000 km) if converting to an approved synthetic lubricant.

Dana Spicer Axles with synthetic lubrication and Out Runner Seals: drain, flush, and refill at 500,000 miles (804,000 km). NOTE In all cases, lubricant supplier assumes full responsibility for the performance of their product, and for product and patent liability. Initial Change: See Preventive Maintenance Schedule on page 5-12 for standard rear axle service intervals. Change mineral-based lubricant in other Dana Spicer and Fabco axle assemblies (new or rebuilt) within the first 3,000 to 5,000 miles (4,800 to 8,000 km). Check and clean the axle housing breather vent at each oil level check. Axle Housing Breather Vent: 5 For recommended types and brands of lubricants, contact your dealer.

Meritor: For petroleum-based axles, use lubricants meeting MIL L2105C/D grade specifications or approved synthetic lubrication. Do not use oil additives. See Meritor Lubrication Maintenance Manual (MM1). 5-128