VEHICLE RECOVERY AND SPRING BRAKES Recovery Hitch Installation Driver Controlled Main Differential If your vehicle is not equipped with the proper recovery hitch assembly, contact an authorized dealer to obtain the proper equipment. Use the following procedure to install the Vehicle Recovery Hitches. See Recovery Hitch Assembly illustration for part identification. Follow these steps to lock a driver-controlled main differential. 2 1. Check square sockets behind lower bumper for obstructions, clear if necessary. An open air line on the recovered vehicle will cause a leak in the air system of the recovery vehicle if both vehicles’ brake systems are connected.
This could cause a loss of system air, which can cause the service brakes not to function, resulting in the sudden application of the spring brakes causing wheel lock-up, loss of control, or overtake by following vehicles. You could be in an accident involving death or personal injury. Ensure that any air line that has been removed from a driver-controlled main differential lock is firmly capped to prevent loss of air pressure from the recovery vehicle if it is supplying air pressure. WARNING 2. With lock pins removed, insert hitches through bumper and into the square hitch socket. 3. Align the hole in the tow hitch with the square hitch socket hole. 4.
Insert the lock pin into the square hitch socket hole and through the hole in the tow hitch until the lock tab is within the square hitch socket. Recovery Hitch Assembly 1 Tow Pin 2 Tow Hitch 3 Square Hitch Socket 4 Lock Pin 5 Lock Tab 5. Rotate the lock pin 90 degrees to secure the pin in place. 6. Remove the hitches and store all parts after recovering the vehicle. 2-15