PACCAR Inc. — Vehicle Recovery Guidelines

VEHICLE RECOVERY AND SPRING BRAKES Failure to lift the driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle could seriously damage your vehicle. All lubricating and clutch application oil pressure is provided by an engine-driven pump, which does not work when the engine is stopped. When vehicles are towed either by wrecker or piggyback, lubricant in the top front of the drive axle will drain to the rear. This will leave the top components dry, resulting in friction that will seriously damage these components. CAUTION Water, dirt and other material can enter an open hub or axle.

This can contaminate the axle fluid and cause possible damage to components. Ensure that the hubs are covered with plastic whenever a drive axle shaft is removed. CAUTION 2 3. For vehicles with driver-controlled main differential lock, install the caging bolt before removing the axle shafts for towing. Driver Controlled Main Differential Lock a. Remove the air line and firmly cap. 1 Air Line (remove to install Caging Bolt) 2 Caging Bolt (in storage location) 2. Cover open hubs when removing drive axle shafts. b. Remove the caging bolt from its storage hole. c. Screw the caging bolt into the air line hole. When fully engaged, a 0.25 - 0.5 in.

(6.35-12.7 mm) space will remain between the air cylinder and the bolt head. 1. Lift driving wheels off the ground or remove the driveline and axle shafts before towing the vehicle. 2-16