. MAINTENANCE MAINTENANCE PROCEDURE CHECK AND ADJUST TRACK TENSION WARNING the work equipment, see "BEFORE STARTING ENGINE (PAGE 3-110)", STARTING ENGINE (PAGE 3-135)", and "WORK EQUIPMENT CONTROLS AND so inspect the bottom surface of Adjustment WARNING the 4 - 29 details "STARTING ENGINE (PA OPERATIO NS (PAGE 3-15 4)" in the OPERATION Wear on pins and bus with working conditions and t track tens ion every no w and then in order to maintain the s tandard tension. For carryi ng out inspec tion and adjustmen t of track shoes, par k th e machine on the flat Checking 1. 2. 3. Run th e engine at l ow idle, then move t a dista the m nce equal to achine. 2.
Put on the track sh oe straight wooden from i dler (1) to up per carrier roller (2). Meas the w ure the maxi ooden bar an mum deflection betw d top surface of the Deflec tion "a" shou ld be 10 - 30 mm (0 If the trac k tension is n ot at the standard v alue, adjust it in t he There is da nger of plug (1) flying out under the hi gh internal pressur e of grease. Ne ver loosen plu g (1) more than 1 turn. Never loos en any part o mounting d irection of plu If the track tension cann please con tact your Kom