. MAINTENANCE MAINTENANCE PROCEDURE Loosening Track Tension WARNING 4 - 30 Increasing Track Prepare a grea 1. Pump in gre ase through g rease fi tting (2) wit h a grease p ump. (Grease fitti ng (2) forms o ne part with plug ( 2. To check if the tension is correc t, run the e idle, move the m achine slowly forward (by an am ount equal t o the length of tra ck on ground ), then s top the ma 3. Check the t rack tension a gain, an d if the tens ion is not correct, adjust it aga 4. Continue to pump in grea se until dimension ( S) becomes zero (0) . If the tension is sti ll loose , the pin and bushing are excessively worn, so the y must be either tu rned or replaced.
Please cont act your Kom atsu distributor for repairs. It is extremely da ngerous to relea se the g rease by any method exce pt the If track tension is not relieved by this procedure, conta ct your Komatsu 1. Loosen plu g (1) gradually to release the gre ase. of one turn. 2. When loose ning plug (1), turn it a maximum 3. If t he greas e does not co me out s moothly, m ove the machine forwards an d backwards a short 4. Tighten plu 5. To check if idle, move the m achine slowly forward (by an am ount equal t o the length of tra ck on ground ), then s top the ma chine. 6. Check the t rack tension a gain, an d if the tens ion is not correct, adjust it aga in.