. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING 1. Turn the valve (1) at the bottom of the fuel tank to the CLOSE position (S). 4 - 56 After the engine has bee n operated, all parts are at high tem perature, so do not replace the filter imme diately. Wait for all parts to cool down before star ting the operation. ed inside the engine fuel piping system when the engine is running. High pressure is generat ed inside the engine fuel piping s ystem when t When replacing the filte r, wait for at least 30 seconds afte r stopping th e engine to let the internal p ressure go down before replacing the filter. lame close.
Do not bring any fire or f NOTICE Genuine Komatsu fuel fi lter cartridges use a special filter that has hig hly efficient filtering ability. When replacing the filter cartridge, always use a g enuine Komatsu part. The common rail fuel inj ection system used on this machi ne consists of more precise parts than th e conventional injection pump and nozzle. If any part other than a g enuine Komatsu filter cartridge is used, dust or dirt may get in and cause pr oblems with the injection system. Always avoid u sing substitute parts. When carrying out inspe ction or maintenance of the fuel s ystem, pay m ore attention than normal to the entry of dirt.
If dirt is stuck to any part, use fu el to wash it off completely. Prepare a container t Prepare a filter wrenc 2. Open the cover on t he right side of the machine. 3. Set the container to c 4. Loosen drain valve ( atch the fuel under the pre-filte 2), then drain all the water and s r cartridge. ediment in the transparent cap cartridge (4). 5. Remove connector ( bag to prevent water (3) and also the fuel accumulated in filter 5). Wrap the removed connector in a vinyl from getting on it. 6. Using a filter wrenc h, turn transparent cap (3) to the left to is used again.) remove it. (This cap