. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE (Machine of poor fuel arrangement specification) then REMARK not to let water get on the connector. If water gets on connector (5), dry it completely before connecting it. 4 - 57 7. Using a filter wrench, turn ca rtridge (4) to the left to remove it. the bottom of the new filter cartridge. lace O-ring (6).) 8. Install transparent cap (3) to the bottom of the new filter cartridge. (When doing this, always rep 9.
When installing, apply oil to th e packing surface and bring the packing surface into conta ct with the seal su of filter cartridge (4) and then If the transparent cap is tight is not tightened enough, fuel securely to the fixed tightenin tighten it further by 1/4 - 1/2 turns. ened too much, the O-ring will be damaged a nd this will cau se leakage of fue will leak through the gap at the O-ring . T o prevent these pro blems, always tig g angle. new filter cartridge with clean fuel, coat the packing surface thinly with oil, 10. Clean the filter holder, fill the install to the filter holder. NOTICE When adding fuel, do not remove small holes (A) on the dirty side.
After adding fuel, remove cap (B) Always fill with clean fuel. Be care the fuel. In particular, center portio cap (B) when adding fuel. Be caref portion on the clean side. 11. When installing, tighten until t he packing surface contacts the seal surface of the filter ho lder, then tighten of a turn. If the filter cartridge is tighten filter cartridge is too loose, fu When tightening with a filt ed too far, the packing will be damaged and this will lead to leakage of fuel. I el will also leak from the packing, so always tighten the co er wrench, be extremely careful not t o dent o r damage the 12. Check that the drain valve (2 13.
Remove the vinyl bag coveri ng connector (5), then connect connecto r (5) If water gets on the connector and the water separator moni connector (5), be extremely c 14. Turn the valve (1) at the bott om of the fuel tank to the OPEN position (O)