Table of tools for field assembly 11 No. Tool name Specification Q'ty Remarks 1 Air compressor Min. 0.69 MPa – 15 m³/min 1 2 Pneumatic hose and cou- pler (for pneumatic tools) Hose length: 30 m Coupler must fit impact wrench and oil feed pump. 1 set For air compressor 3 Crane truck Lifting load: 50 ton Lifting load: 25 ton 2 1 4 Welder 2 For welding blade spill guard (If equipped) 5 Chain lever hoist (Chain block) Rated load 1.5 ton 1 JIS B8819 or equivalent Rated load 3.2 ton 1 Rated load 6.3 ton 1 6 Wire rope sling ø 36 × 6 m 4 Specification: JIS B8817 or equivalent ø 20 × 5 m 2 ø 12 × 2 m 4 7 Belt sling (made of synthetic fibers) 25 mm wide × 3 m 2 Specification:
JIS B8818 or equivalent 50 mm wide × 3 m 1 8 Hydraulic wrench Min 5,890 Nm {600 kgm} 1 Mainly for master link bolt 9 Hydraulic wrench socket Width across flats: 46 1 unit each For master link bolt 10 Extension bar T 38.1 × L300 1 11 Air impact wrench See No. 41 12 Socket for impact wrench Width across flats: 19, 22, 24, 27, 30, 32, 36, 41, 46, 50 1 unit each Must fit impact wrench No. 41. 13 Torque wrench Tightening capacity 588 Nm {60 kgm} 1 Impact wrench socket may be used if it fits. Tightening capacity 1,370 Nm {140 kgm} 1 Tightening capacity 2,060 Nm {210 kgm} 1 14 Soket for torque wrench Width across flats: 32, 36, 41, 46 1 unit each 15 Eyebolt M12, Using load:
220 kg 4 M16, Using load: 450 kg 2 For blade center link 16 Shackle SD22 4 Specification symbols are quoted from JIS B2801 BC36 2 SB44(T) 2 17 Sledge hammer Double-headed: 4.5 kg (10 lbs) 1 18 Pinch bar (Lever) ø 25 × 900 mm 1 JCMAS P018 or equivalent, Note 1) 19 Thread repair tap M33 × Pitch 2 1 For master link M30 × Pitch 3 1 M24 × Pitch 3 1 20 Jack Screw type, Using load: 15 ton 2 For assembling track frame 21 Single ended wrench Nominal width across flats (mm) 17, 19, 22, 24, 27, 30, 32, 36, 41, 46, 50 2 units each For tightening hydraulic hose mouthpiece nut 22 Lubricating oil and grease See assembly procedures A-3 and A-18.
— 23 Anti-seize compound Molybdenum disulphide grease (LM-P) 200 g See coating material list. 24 Cleaning oil For removing preservative 40 l 25 Paint remover For removing phthalate resin coating 5 l 26 Paint for repair See coating material list 3 units each