Note 1) Pinch bar (Lever) No. 18 is P018-1978 (Pinch bar) of JCMAS (Japan Construction Mechanization Association) or equivalent. You can read the information about JCMAS on the website. Note 2) Hydraulic wrench No. 8 may be used instead of pneumatic impact wrench No. 41 having tightening capacity of 1,000 – 6,500 Nm {102 – 663 kgm} (suitable for tightening M27 bolt or larger), as long as the sockets are adaptable. Note 3) This list does not contain general hand tools (box wrenches, screwdrivers, pliers, etc.) Prepare them separately as required. 12 No.
Tool name Specification Q'ty Remarks 27 Glass cleaner Cleaning liquid (commercially available) 1 For cleaning operator cab windshield glass 28 Cloth Bunch 1 kg 29 Adhesive cloth tape Width × Length × Color 50 mm × 25 mm × Not specified 1 roll 30 Plastic tube (Vinyl tube) 8 mm inside diameter × 1 mm thick × 3 m long, soft, transparent 1 For checking airtightness (internal pres- sure) of operator cab 31 Oil feed pump Manual or pneumatic 1 32 Oil mug Capacity: Approx.
5 l 1 33 Drain oil receiver (made of steel sheet) 1,000 × 700 × 150 (mm) 700 × 400 × 150 300 × 300 × 100 2 units each 34 Stand for high lift work 2 m high, with stair and handrail 2 35 Safety belt Waist belt type Same as number of workers 36 Safety glasses Same as number of workers 37 Stand (for setting machine) For attached tool drawing 1 Front For attached tool drawing 1 Rear 38 Steel plate liner (for install- ing support stand No. 37) 1,000 × 500 (mm) 16 mm thick 4 With lifting hook 39 Sling for track fame For attached tool drawing 1 40 Wood block T 350 mm × 750 mm high 4 T 350 mm × 400 mm high 4 T 100 mm × 750 mm lengh 4 41 Pneumatic impact wrench Tightening capacity Unit:
Nm {kgm} Objective bolt thread diameter 1 Note 2) – 200 {20.4} M10 – M14 1 Socket No. 12 must fit this impact wrench. – 600 {61.2} M16 – M20 1 – 1,000 {102} M22 – M24 1 – 3.000 {306} M27 – M38 1 – 6,500 {663} Min. M39 1 42 Common tools Note 3)