11 10 9 8 7 6 5 4 3 2 1 5. Tighten the locknut at the clutch lever. 6. Turn in the adjusting bolt at the rear brake cal- iper by hand until it feels tight, then turn it out NOTE: If the cable length cannot be adjusted to specifica- tion, consult a Yamaha dealer. 1. Locknut 2. Adjusting bolt 3. Loosen the locknut and the adjusting bolt at the rear brake caliper. 4. Turn the adjusting bolt at the clutch lever in di- rection (a) to increase the cable length, and in direction (b) to decrease it. 1 2 (a) (b) 8-37 When tightening the locknut, hold the adjust- ing bolt with a wrench so that it does not turn together with the locknut. CAUTION: ECB00520 Tightening torque:
Locknut (rear brake caliper): 16 Nm (1.6 m·kgf, 11 ft·lbf) 1. Adjusting bolt 2. Locknut 1/8 turn and tighten its locknut to the specified torque. 1 2