NOTE: The brake light switch is properly adjusted when the brake light comes on just before braking takes EBU24740 Brake light switches The operation of the brake light switches must be checked and, if necessary, adjusted at the inter- vals specified in the periodic maintenance and lu- brication chart. The brake light switch for the brake pedal can be adjusted as follows, but the other brake light switches should be adjusted by a Yamaha dealer. Operating with improperly serviced or adjust- ed brakes could cause the brakes to malfunc- tion, resulting in reduced braking performance. This could increase the chance of a collision or accident.
After adjusting the parking brake free play, block the rear of the ATV off the ground and spin the rear wheels. Check to make sure there is no brake drag. If brake drag is noticed, perform the adjustment again. EWB02090 WARNING 8-38 EBU24810 Adjusting the clutch lever free play The clutch lever free play must be checked and, if necessary, adjusted at the intervals specified in the periodic maintenance and lubrication chart. The clutch lever free play should measure as 1. Brake light switch 2. Brake light switch adjusting nut Turn the adjusting nut while holding the brake light switch in place. To make the brake light come on earlier, turn the adjusting nut in direction (a).
To make the brake light come on later, turn the adjust- ing nut in direction (b). effect. 1 2 (a) (b) 11 10 9 8 7 6 5 4 3 2 1