Komatsu — ANGLING BLADE

OPERATION 2 STRAIGHT ANGLE DOZER - D87E-2 2 ANGLING BLADE When adjusting the angle, it is dangerous if the work equipment is moved by mistake. Set the work equipment in a safe condition, then stop the engine. Be careful when removing the upper/lower strut. After the 2nd up- per/lower strut is removed the blade can move freely on its center hinge. 2 Straight to Angle Following is straight to left angle with right angle being the opposite. 1. Raise blade 400 to 500 mm (15.8 to 19.7 in) above ground, then put blocking under the C frame. Make sure that all of the load is off of the upper struts before the lower strut is removed from the C frame bracket. 2.

Remove the pin securing left upper/lower strut to C frame and re- move strut from mounting bracket. Keep it close to the C frame. Stay clear of blade when performing above steps. Swinging the blade will cause lost of balance and drop of blade on the side of swung strut. 3. Remove the pin securing right upper/lower strut to C frame and re- move strut from mounting bracket. Carefully swing the right strut out as far as it will go to regain blade balance. 4. From the other side of machine, swing out the strut, level the blade and maintain this level position while repositioning the blade, changing the angle. 5. Connect the rear most upper/lower strut to C frame first and secure with the pin.

Connect and secure the remaining upper/lower strut. If necessary, adjust the upper strut to align the lower strut with the C frame bracket. 6. After angling the blade, it should be leveled so that when the blade is resting on the ground, one corner does not dig in more than the other. This may be accomplished by adjusting the upper struts. If only a small amount of adjustment is required, it will not be neces- sary to remove the strut trunnion from its bracket on the C frame. To raise one end of the blade, lengthen the upper strut on that side. To lower one end of the blade, shorten the upper strut.

After level- ing the blade, lengthen the upper struts so that there is a compres- sion bind on them to eliminate free play. This will allow the blade to maintain an even grade. 2-72 D87E-2 D87P-2