Komatsu — TILTING THE BLADE

2 Angle to Straight OPERATION 1. Raise blade 400 to 500 mm (15.8 to 19.7 in) above ground, then put blocking under the C frame. Make sure that all of the load is off of the upper struts before the lower strut is removed from the C frame bracket. 2. Remove the pin securing the forward upper/lower strut to C frame and remove strut from mounting bracket swing out all the way. Stay clear of blade when performing above steps. Swinging the blade will cause lost of balance and drop of blade on the side of swung strut. 3. Remove the pin securing rear upper/lower strut to C frame and re- move strut from mounting bracket. 4.

Level the blade and maintain this level position while repositioning the blade, changing the angle to straight. 5. Move either upper/lower strut until it contacts C frame and mount. Use caution, since the blade will drop on the opposite side because of the lack of balance. 6. Assemble the strut on the opposite side into its bracket on the C frame and secure. If necessary, adjust the upper strut to align the strut with the bracket. 7. After straightening the blade, it should be leveled so that when rest- ing on the ground, one corner does not dig in more than the other. This may be accomplished by adjusting the upper struts.

If only a small amount of adjustment is required, it will not be necessary to remove the strut trunnion from its bracket on the C frame. To raise one end of the blade, lengthen the upper strut on that side. To lower one end of the blade, shorten the upper strut. After leveling the blade, lengthen the upper struts so that there is a compression bind on them to eliminate free play. This will allow the blade to maintain an even grade. 2 TILTING THE BLADE When adjusting the amount of tilt, it is dangerous if the work equip- ment is moved by mistake. Set the work equipment in a safe condi- tion, then stop the engine.

2 Hydraulic Tilt On machines equipped, blade tilt to either side is determined by the rod movement of each of the dual cylinders. D87E-2 D87P-2 2-73