OPERATION 2 STRAIGHT DOZER - D87P-2 2 GENERAL In addition to raising or lowering, the blade can be hydraulically tilted or manually pitched. 2 BLADE TILT 2 Equal Tilt 1. Right Tilt 2. Left Tilt Remark Equal tilt is accomplished in the normal blade position, when the back of the blade is perpendicular (90°) to the ground and the blade cutting edge is 52° to the ground with the left upper strut at its mean dimension. 1. Move blade control lever to the side in which the blade is to be tilted until the desired movement is obtained. 2. Place the lowest corner of the blade on a flat surface. 3.
Hold the control lever in position on the side to which the blade is to be lowered until the blade is even along the flat surface. 2 Over Equal Tilt Remark When this tilt adjustment is selected, there will no longer be equal tilt at each side of the blade. Position blade in maximum equal tilt to side selected. Use the left upper strut to change the tilt as follows; Left Tilt Tilt cylinder extended so decrease strut length Right Tilt Tilt cylinder retracted so increase strut length 2 PITCHING THE BLADE 2 Normal Blade Position Normal blade position is obtained when the left upper strut is at its mean dimension and the back of the blade is perpendicular (90°) to the ground.
In this position the blade cutting edge is now 52° to the ground. 2 Forward Pitch, Increased Penetration Angle Raise the blade about 450 mm (17.7 in) off of the ground. Then extend the upper strut on the left side of the blade to the desired increased pitch. 2 Rearward Pitch, Decreased Penetration Angle Raise the blade about 450 mm (17.7 in) off of the ground. Then retract the upper strut on the left side of the blade to the desired decreased pitch 2-76 D87E-2 D87P-2