OPERATION 2. Remove the locking pins and adjust both upper struts so that the gap between the shoulder of the eyebolt and strut body is 39 mm (1.53 in) on each end. This will position the blade in its neutral tilt position. If the blade is not level, a half turn of the upper strut in ei- ther direction will level the blade. 3. After leveling the blade, raise it above the ground 300 mm and shut off the engine. Adjust the upper struts to a neutral position (no com- pression or tension) so the blade connecting pins are free to revolve in their brackets. 4. Having determined the neutral position, shorten each upper strut by one full turn.
Remark Adjustment made in step 4 must be made only if all strut ad- justments have been made with blade raised off the ground. 5. Reinstall the upper strut locking pins. D87E-2 D87P-2 2-75