OPERATION 2 CHASSIS 2-94 D87E-2 D87P-2 PROBLEM MAIN CAUSE REMEDY When transmission lever is moved to the desired position, machine does not start or traveling speed is low • Oil pressure of drive train is not raised 1. Insufficient oil in system Add oil to specified level, see “CHECK OIL LEVEL IN DRIVE TRAIN” on page 3-30 When transmission steering lever is moved to turn machine, machine does not turn and goes straight • Steering clutch of moved side is not dis- engaged. . . . . . . . . . . . . . . . . . . . . . . . . • Brake of moved side is not actuated. . . Adjust brake Adjust brake When brake pedal is depressed, machine does not stop • Brake out of adjustment . . . . . . . . . . . .
Adjust brake Track comes off • Track too loose . . . . . . . . . . . . . . . . . . . Adjust tension, see “CHECK AND AD- JUST TRACK TENSION” on page 3-30 Abnormal wear of sprocket • Track too loose or too tight . . . . . . . . . Blade rises slowly, does not rise • Lack of hydraulic oil . . . . . . . . . . . . . . Add oil to specified level, see “CHECK OIL LEVEL IN HYDRAULIC TANK” on page 3-24 Does not steer when steering levers are operated • Defective hydraulic pressure at steering clutch . . . . . . . . . . . . . . . . . . . . . . . . . . {Check, repair} Noise generated from idlers or rollers • Lack of oil in idler or rollers . . . . . . . . Add oil to specified level.
see “TIPS FOR LONGER UNDERCARRIAGE LIFE” on page 2-78 Blade control lever is not held at float • Insufficient warm up . . . . . . . . . . . . . . Carry out warm up Transmission pressure does not rise • Wear, scuffing of gear pump . . . . . . . . • Lack of oil in power train case. . . . . . . • Element of oil strainer clogged . . . . . . {Check, replace} Add oil to specified level. see “CHECK OIL LEVEL IN DRIVE TRAIN” on page 3-30 Clean. see “DRIVE TRAIN SUCTION STRAINER” on page 3-34 Lacks drawbar pull, cannot travel at full speed • Lack of drive power from engine. . . . .
See ENGINE on next page Machine does not move off when trans- mission lever is placed in gear • Lack of oil in power train case. . . . . . . • Transmission pressure does not rise. . . • Steering clutch is slipping . . . . . . . . . . 1. Wear, scuffing of gear pump Add oil to specified level, see “CHECK OIL LEVEL IN DRIVE TRAIN” on page 3-30 See Transmission pressure does not rise above {Check, replace} Torque converter overheats • Lack of oil in power train case. . . . . . . • Transmission pressure does not rise. . . • Steering clutch is slipping . . . . . . . . . . 1. Wear, scuffing of gear pump • Excessive load when operating . . . . . . Add oil to specified level.
see “CHECK OIL LEVEL IN DRIVE TRAIN” on page 3-30 See Transmission pressure does not rise above {Check, replace} Shift down one speed, or reduce load and increase the speed when operating