MAINTENANCE 3 COOLING SYSTEM 3 GENERAL The cooling system operates under pressure which is controlled by the pressure relief valve in the radiator cap. The belt driven water pump circulates the coolant through the engine block, cylinder heads, radiator, and engine oil cooler. Circulation is con- trolled by the thermostat which by passes coolant flow around the radiator until the engine reaches operating temperature. Proper cooling is possible only when the system is sealed, the radiator cap gasket is in good condition, the pressure relief valve and thermostat are operating properly. The system is free of coolant and air flow restrictions and filled to the proper level.
Selection and maintenance of the engine coolant is important to long engine life. The following information provides recom- mendations for selecting the engine coolant, maintaining the coolant inhibitors and servicing the cooling system. The system operates successfully with a water/antifreeze mixture or inhibited/conditioned water as the coolant. Water alone allows rust, scale deposits, and corrosion to occur within this system. After 2000 hours or one year of operation, whichever comes first, the cooling system should be drained, flushed and refilled. 3 WATER Use water which has a low mineral content.
Water used in conjunction with antifreeze, coolant filters and inhibited water must meet the following standards: 3 Total Hardness Not to exceed 170 parts per million (10 grains/gallon maximum) to prevent scale deposits. Water containing dissolved magne- sium and calcium (the usual reason for water hardness) above the specified amount will cause scale deposits to develop in the engine. 3 Chlorides Not to exceed 40 parts per million (2.5 grains/gallon maximum) to prevent corrosion. 3 Sulfites Not to exceed 100 parts per million (5.8 grains/gallon maximum) to prevent corrosion.
3 Dissolved Solids Not to exceed 340 parts per million (20 grains/gallon maximum) to minimize sludge deposits, scale deposits, corrosion or a combination of these. If any of the requirements cannot be met, use distilled, de-ionized, or de-mineralized water. To deter- mine if local water supplies meet these standards, water samples can be tested by water treatment laboratories. Softened water that is prepared using common salt (sodium chloride) contains excessive amounts of chlorides and should not be used. Remark Never use water alone in the cooling system because corrosion will occur. 3 ANTIFREEZE Low silicate ethylene glycol antifreeze is recommended.
The antifreeze should contain no more than 0.1% anhydrous alkali metasilicate. Low silicate antifreeze is recommended to avoid the formation of silica-gel (hydro-gel). This gel formation can occur when the cooling system contains an over concentration of high silicate antifreeze and or supplemental coolant additive. Do not use methanol or alcohol as an antifreeze because of its low boiling point. Antifreeze may retain its freeze protection for more than one season but coolant conditioners must be added to maintain corrosion protection. Antifreeze formulated with methoxy propanol, or propylene glycol, is not recommended for this system. Remark Do not mix types of antifreeze solutions.
Mixed solutions make it impossible to determine the protection against freezing. Antifreeze containing sealer or antileak additives should not be used in this system. Sealer or antileak additives will cause plugging problems in the cooling system. 3-10 D87E-2 D87P-2