Komatsu — TRUNNION HARDWARE

MAINTENANCE 3 SERVICE PROCEDURE 3 INITIAL 10 HOURS SERVICE 3 BLADE CUTTING EDGE HARDWARE Check the torque of the blade cutting edge and end bit hardware. Plow bolt nuts 725 N•m (535 lbf ft) 3 TRACK SHOE BOLT TORQUE The bolts used for attaching the track shoes to the tracks are heat treated alloy bolts and will stand a considerable tightening strain. Ordinary bolts must not be used. Nuts must be assembled so that washer face is not against track link. Radius side of nuts must be against track link. Torque bolts to listed value below. Threads and under bolt head Engine oil Track shoe bolt 400 ± 70 N•m (295 ± 52 lbf ft) + 120° 120° designates two flats of bolt head.

3 TRUNNION HARDWARE Check the torque of the trunnion cap bolts (1), qty. 4, and trunnion plate mounting bolts (2), qty.16. Trunnion hardware 1050 N•m (775 lbf ft) 3-22 D87E-2 D87P-2