Komatsu — CHECK OIL LEVEL IN HYDRAULIC TANK

MAINTENANCE 2. Check the oil level. For an accurate reading wait for the oil to drain into the crankcase pan. 3. Open hood access door. Remove the oil level gauge (1) and wipe it clean. Reinsert the gauge completely. 4. Remove the gauge and check the oil level. If the level is at or below the L mark, add oil through the filler opening (2) to bring the level up to the H mark on the gauge. For details of the oil to use, see “USE OF FUEL, COOLANT AND LUBRICANTS” on page 3-7 Never run the engine if the level of the oil is at or below the ADD mark on the oil level gauge. 3 CHECK OIL LEVEL IN HYDRAULIC TANK Pressurized Reservoir.

When removing the locking filler cap, oil may spurt out, so stop the engine and wait for the oil temperature to go down. Turn the cap slowly to release the internal pressure before re- moving the cap. 1. Check the hydraulic oil level in the tank at the sight gauge. The proper level is: When cold: At bottom of sight gauge When hot: At center of sight gauge 2. Remove the locking filler cap and add oil to the proper level, then reinstall the filler cap. For details of locking cap, see “LOCKING CAP” on page 2-29. For details of the oil to use, see “USE OF FUEL, COOLANT AND LUBRICANTS” on page 3-7 3-24 D87E-2 D87P-2