MAINTENANCE 3 EVERY 50 HOURS SERVICE Perform maintenance for every 10 hours of service at this time. 3 CHECK OIL LEVEL IN DRIVE TRAIN 1. Open the rear access door. Unscrew the T handle of the oil level gauge, remove the gauge and wipe it clean. 2. Insert the gauge fully into the filler sleeve. Do not tighten. Remove gauge and check the lubricant level. If necessary, add oil through the filler to bring the level up the FULL mark on the gauge. Rein- stall and secure the gauge. For details of oil to use, see “USE OF FUEL, COOLANT AND LUBRICANTS” on page 3-7 3 RADIATOR CORE Remove dirt from the radiator core by blowing it through with com- pressed air in the direction opposite to the fan.
Clean as required as by the condition of the radiator core. 3 CHECK AND ADJUST TRACK TENSION 3 Proper Adjustment Tracks adjusted too tightly increase operating loads on final drives and accelerate wear on undercarriage components, especially in packing conditions. In forward operation with correctly adjusted tracks will ex- perience track loads only along the ground from the front idler to where the bushings engage the sprocket. Lubed track systems are adjustable to provide a sag in the chain between to front top idler and the front idler. Correct tension reduces stress levels throughout the undercarriage. 3 Checking Tension 1.
Place a wooden block, 305 mm (12 in) in height, under the front most track shoe lug. Drive the machine forward until the track chain is tight along the ground and around the sprocket. Apply and lock brake pedal, lock trans shift lever in neutral and stop the en- gine. 2. Stand on the track between the front idler and the first track idler in order to accumulate all the chain slack at this point. Place a straight- edge on the track so the ends rest over the front idler and track idler. Measure the clearance between the bottom of the straightedge and the top of the shoe grouser with a ruler at the midway point between the idlers.
If the distance is more than 64 mm (2.5 in) or less than 38 mm (1.5 in), adjust the track tension. 3-30 D87E-2 D87P-2