MAINTENANCE 3 Adjusting Tension The track chains are adjusted by hydraulic pressure. When lubricant is introduced into the front idler fork through the lubrication fitting, it acts upon the piston within the front idler fork forcing the front idler fork and front idler forward for track adjustment. To avoid possible injury, always stand to the side of the bleeder plug when making track adjustment. The pressure in the front idler fork is held by the bleeder plug and check valve. A loose or improper thread fit of either of these parts can allow them to be ejected by the pressure of the lubricant, causing possible injury.
When increasing track tension, be sure the bleeder plug and check valve are properly torqued. When relieving track tension, never loosen the bleeder plug and check valve more than 2-1/2 turns. Before adding lubricant for track adjustment, be sure the ball check and relief valve are properly torqued. 1. Remove hardware and open track adjuster cover (1). To increase track tension, connect a lubricator nozzle to the fitting (2). Deter- mine the amount of adjustment necessary, and add lubricant to ob- tain proper chain tension. It is advisable to move machine forward and backward slightly to be sure correct tension has been obtained. 2.
To reduce track tension, loosen the relief valve (3) 1/2 to 1 full turn to allow the pressurized lubricant to escape through the relief pas- sage. If the lubricant does not appear, loosen the check valve (4), (located under the lubrication fitting), 1/2 to 1 full turn to allow the pressurized lubricant to escape from a second relief passage. 3. If lubricant still does not appear, use the following emergency method. Should relief passages still be blocked, unscrew ball check and/or relief valve an additional 1-1/2 to 2 turns (2-1/2 total turns). This will allow a greater amount lubricant to free the passages. Use extreme care when relieving pressure with the following emergency method.
If loosened excessively, the ball check or relief valve can be ejected by the cylinder pressure. Never loosen these parts more than a total of 2-1/2 turns. 4. When the proper tension has been obtained, tighten the ball check and/or relief valve to value given below. Close the cover and secure with removed hardware. Ball Check or Relief Valve 68 N•m (50 lbf ft) Remark Never remove one link to bring a stretched track to within range of proper track adjustment. A track that is worn badly enough to take up the length of one link, will be so far out of pitch that the increased wear on the sprocket will far more than offset the saving obtained by the removal of one link in the chain.
D87E-2 D87P-2 3-31