MAINTENANCE 3 EQUIPMENT SYSTEM RETURN FILTER Remark If the filter indicator light on the instrument panel, remains on at operating oil temperature with the engine running, the filter cartridge must be changed. 1. With the engine stopped, operate the equipment levers several times to relieve any pressure. Open the right access side door. Re- move all outside dirt from filter. 2. Using a filter wrench remove the spin on filter. Wipe the filter base, removing all of the old oil from the seal area. 3. Fill the new filter with clean oil, then coat the filter seal with clean oil. 4.
install the filter by threading (do not spin) it onto the filter base (3) until the seal contacts the base, turn the filter by hand an additional 1/4 to 1/2 turn. Remark Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. Mechanical over tightening may distort the filter header threads or dam- age the element seal. 5. Check the level in the equipment hydraulic system. D87E-2 D87P-2 3-37