MAINTENANCE 3 CHANGE EQUIPMENT SYSTEM OIL 1. Start the engine and operate the blade to warm the oil for easy draining. Park the machine on level ground, lower blade and ripper equipment to the ground. Stop the engine. Shift to neutral and apply the lock lever. Apply and lock the parking brake. Turn the electrical system master switch and dash key to OFF and remove keys. Pressurized Reservoir. Always loosen the locking cap slowly in case there is still some pressure in the system. 2. Slowly loosen and remove reservoir locking cap to relieve reservoir pressure, see “LOCKING CAP” on page 2-29. 3. Remove radiator drain access plate.
Remove the magnetic drain plug and drain the reservoir into a suitable container. 4. This screen filters the oil entering the tank and eases the job of the oil filter. Remove and clean the screen with a nonflammable com- mercial cleaning solvent. Install the screen in the reservoir and mount locking cap. Fire hazard - do not use kerosene, diesel fuel or flammable liquids to clean parts. A spark or a flame could cause a fire or an explosion. Use a nonflammable commercial solvent. 5. Remove reservoir top cover and discard o-ring. Using a M24 socket and extension, remove strainer assembly from reservoir. 3-38 D87E-2 D87P-2