MAINTENANCE 3. After all the oil is drained, close the drain valve (4), remove hose (3) and install drain plug (2). Drain valve . . . . . . . . . . . . . . . . 58 to 78 N•m (43 to 57 lbf ft) Drain plug . . . . . . . . . . . . . . . . . 48 to 78 N•m (37 to 57 lbf ft) 4. Open the engine left side access panel. The engine oil filter is a spin on type. This filter cannot be cleaned and should not be disturbed except when it is necessary to replace it. Remark Use only a recommended genuine filter available from your distributor. 5. Clean the outside of the filter. Remove the spin on type filter by turning it counterclockwise. Discard the old filter in a suitable, cov- ered refuse container.
When doing this, to prevent getting oil on yourself, do not carry out this operation from immediately under the cartridge. Clean the filter header. In particular, if this operation is carried out immediately after stop- ping the engine, a large amount of oil will come out, so wait for 10 to 15 minutes before starting the operation. 6. Fill the new filter element with clean engine oil and apply a little clean engine oil to the seal. 7. Thread the filter on by hand (do not spin) by turning it clockwise until the seal just makes contact the filter header. Give the element an additional 3/4 to 1 turn.
Remark Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. Mechanical over tightening may distort the filter header threads or dam- age the element seal. 3-46 D87E-2 D87P-2