MAINTENANCE 2. Using a filter wrench remove the spin on filter. Wipe the filter base, removing all of the old oil from the seal area. 3. Fill the new filter with clean oil, then coat the filter seal with clean oil. 4. Install the filter by threading (do not spin) it onto the filter base (3) until the seal contacts the base, turn the filter by hand an additional 1/4 to 1/2 turn. Remark Do not over tighten the filter or use any tools for installation because this can damage the gasket and filter. Mechanical over tightening may distort the filter header threads or dam- age the element seal. 5. Check the level in the drive train system.
3 REPLACE DRIVE TRAIN SYSTEM BREATHER Remark To prevent dirt from entering the critical areas of the drive train system, keep the breather clean. 1. Open the right rear access door. D87E-2 D87P-2 3-55