Komatsu — DRAIN, FLUSH AND REFILL FINAL DRIVE OIL

MAINTENANCE 2. The breather is located on a stand pipe at the right rear top of the rear main frame cover. Unscrew the breather from the reducer nip- ple and discard. Install the new breather on the nipple. 3 DRAIN, FLUSH AND REFILL FINAL DRIVE OIL Drain one side of the machine at a time. 1. While the lubricant is at operating or ambient temperature, park the machine on level ground with the outside drain plug at the lowest point. Remove drain plug and allow the lubricant to drain into a suitable container. Install and tighten the drain plug. The outside drain plug shown here is 152° from level ground. 2.

Remove the inside drain plug and allow the lubricant to drain into a suitable container. Install and tighten the drain plug. 3. Move the machine so that the OIL LEVEL filler/check plug is par- allel to the track frame. 4. Remove the filler and level plug. Fill the housing with fuel oil up to the filler and level plug opening and install the pipe plug. 5. Operate the machine in low gear (with no load) for a few minutes. Position machine so that outside drain plug is at the bottom. Re- move the drain plugs and thoroughly drain the fuel oil into a suit- able container. Reinstall and tighten the drain plugs. 3-56 D87E-2 D87P-2