MAINTENANCE 5. Carefully tap the side or end of the element against the palm of your hand to remove loose dust. Direct clean dry compressed air up and down the pleats on the inside of the element, then direct it from outside along its folds and again from inside. Remark If small holes or thinner parts are found on the element when it is checked with an electric bulb after cleaning, replace the element. Do not use an element whose folds or gasket or seal are damaged. Do not tap the element against a hard surface; this will damage the element. 6. Inspect the filter element for leaks or damage by placing a bright light inside the element.
Inspection of the element on the outside will disclose any holes where concentrated light shines through. The slightest rupture requires replacement of the filter element. 7. Remove baffle (10) and vacuator valve (11) from end cover (10). Clean all parts and reassemble. Remark Remove one seal from the outer element. The number of times the outer element has been cleaned can be seen by the number of removed seals. Replace the outer element which has been cleaned six times repeatedly or used throughout a year and the inner element at the same time. Replace the element when service light illuminates soon after installing the cleaned element even though it has not been cleaned six times. 8.
Replace seal washer (7) and/or wing nut (6) with new parts if they are broken. 9. Insert the open end of the outer element (5) into the air cleaner body and secure with the wing nut and seal washer. 10. Position retainer clamp (13) with new o-ring (12) on cleaner body. Install the end cover (9) onto the air cleaner body. Secure with the wing nut (1) making sure the cover is not cocked. Tighten T bolt of retainer clamp so that distance A at the inside face of the clamp is 17 ± 2 mm (0.67 ± 0.08 in). 11. Inspect and tighten all air cleaner connections before resuming op- eration. Start the engine.
If the air cleaner filter service light contin- ues to show air flow restriction, replace the primary or primary and safety filter element. D87E-2 D87P-2 3-67