Komatsu — BLADE CUTTING EDGES AND END BIT BOLT TORQUE

MAINTENANCE 3 SEAT BELT Seat Belt - Do not clean with solvents or bleach or redye color of the webbing as this may cause a severe loss of strength. This could cause the webbing to break and result in personal injury. Wash in warm wa- ter with a mild detergent. Keep the belt flat to avoid twisting and roping when not being used. Do not place heavy or sharp objects on the belt. The entire assembly should be inspected periodically for corrosion, wear, fraying or wear spots. The mounting bolts should also be periodically inspected for tightness. 3 ROPS MOUNTING BOLT TORQUE Check the torque of the ROPS mounting bolts.

ROPS bolts 780 N•m (575 lbf ft) 3 TRACK SHOE BOLT TORQUE The bolts used for attaching the track shoes to the chains are heat treated alloy bolts and will stand a considerable tightening strain. Ordinary bolts must not be used. Nuts must be assembled so that the washer face is not against the track link, radius side of the nuts must be against the track link. Torque the bolts to listed value below. Threads and under bolt head Engine oil Track shoe bolt 400 ± 70 N•m (295 ± 52 lbf ft) + 120° 120° designates two flats of the bolt head. 3 BLADE CUTTING EDGES AND END BIT BOLT TORQUE Check the torque of the blade cutting edge and end bit nuts. Plow bolt nuts 725 N•m (535 lbf ft) D87E-2 D87P-2 3-81