Komatsu — SEAT

OPERATION 2 SEAT, SEAT BELT AND ARM RESTS 2 SEAT This seat can be adjusted using the following seven functions. Adjust the seat position at the beginning of each shift or when opera- tors change and fasten the seat belt. Adjust the seat so that the brake pedal can be depressed all the way with the operator’s back against the seat back rest. Height Adjustment (1) This seat is equipped with a spring held three stop mechanical height positioner. To actuate the height mechanism, lift up the seat to next stop position. Lifting past the top position will return the seat to the bottom position.

Bottom to top adjustment 76 mm (3 in) in 2 stages Weight Adjustment Knob (2) Turn the knob clockwise or counterclockwise to adjust the seat to the desired strength. Check the indicator (3) as necessary. Fore Aft Adjustment Lever (4) Move the lever and slide the seat back and forth to it where it is com- fortable and easy to operate, then release the lever. Fore and aft adjustment: 52 mm (6 in) in 13 stages Swivel Adjustment Knob (5) Move the lever to rotate the seat left or right when operating any rear mounted equipment. Center to left or right swivel 14° Lumbar Support Knob (6) The tension of the lower rear seat back can be adjusted with the knob.

Turn the knob until the desired amount of lumbar support is achieved. Lower Seat Tilt Control Lever (7) Move the lever to tilt the lower seat to the desired position. Up and down tilt: 10° total Seat Back Tilt Control Lever (8) Move the lever to tilt the seat back to the desired position. Front to back swivel: 115° in stages of 2.5° 2-20 D87E-2 D87P-2