OPERATION 2 CHECK BEFORE STARTING 2 Check and Refill Coolant Do not remove cap while coolant is hot. Hot coolant may spurt out. When removing cap, wait until the coolant temperature goes down and release radiator pressure little by little by loosening slowly, then remove the cap. 1. Check the coolant level in radiator sight glass to make sure coolant is present. 2. Open the hood access door at the top front of the machine. 3. Remove radiator cap and check that the coolant level is visible. If level is low, add coolant until it is visible in sight gauge. For details of the coolant to use, see “USE OF FUEL, COOLANT AND LUBRICANTS” on page 3-7. 4.
After adding coolant, tighten the cap securely and close the access door. 2 Check Fuel Level When adding fuel, never let the fuel overflow. This may cause a fire. If spilling fuel, thoroughly clean up any spillage. 1. Check the fuel level using the fuel gauge. D87E-2 D87P-2 2-33