Komatsu — COLD OPERATION

OPERATION 2 COLD OPERATION 1. Pull throttle lever to the center position between low and high idle and run the engine at medium speed for about 10 minutes with no load. 2. Operate blade control lever to the full raise position, then keep the blade raised to the maximum height and continue to relieve the cir- cuit for 10 minutes. 3. Finally, operate blade control lever and ripper control lever together to operate all the cylinders several times. If the oil temperature in the work equipment is not properly raised, there will be a time lag in the response of the work equipment and steering.

Remark If the oil temperature in the power train is not raised properly, it will take longer to accelerate to the maximum speed. 4. After warm up run is completed, check gauges and warning lights for proper operation. If any abnormality is found, repair it. Con- tinue to run the engine at light load until the engine coolant temper- ature gauge indicator falls within the green range. 5. Check that there is no abnormal exhaust gas color, noise, or vibra- tion. If any abnormality is found, repair it. D87E-2 D87P-2 2-51