Komatsu — MOVING THE MACHINE

OPERATION 2 MOVING THE MACHINE When moving the machine, check that the area around the machine is safe, and sound the horn before moving. Clear all personnel from the machine and the area. Clear all obstacles from the path of the machine. Use extreme care when reversing the machine. Note there is a blind spot behind the machine. When starting on slopes, always keep the brake pedal depressed even after releasing brake lock lever. When starting on a steep uphill grade, run the engine at full throttle and move gear shift lever into 1st F (forward) or R (reverse) position with brake pedal depressed.

When the machine has started slowly (or track shoes slip), propel the machine by slowly releasing brake pedal. 1. Pull the fuel control lever to the high idle position ( A ). 2. Pull the blade control lever ( A ) rearward to raise the blade 360 to 508 mm (15 to 20 in) off the ground. If equipped, pull the ripper control lever ( B ) rearward to raise the ripper 360 to 508 mm (15 to 20 in) off the ground. 3. Depress the brake pedal to release the brake lock. 4. Move the safety lock lever down to the unlocked position. 5. Release the brake pedal and the machine will start to move. Move the transmission lever to the desired position; 1st, 2nd, or 3rd in ei- ther the Forward or Reverse position.

The lever has a detent at whatever position is selected. 2-52 D87E-2 D87P-2