OPERATION 2 DOWNGRADE OPERATION When operating down hill, always put the transmission in the low range position. Use the brake pedal to slow the machine. Never go down hill with the transmission controls in neutral. Failure to do so could result in losing control of the machine and a rollover could result. Before going down a grade, select a gear range which will provide full machine control without over speeding the engine. Steering is handled in the same manner as when traveling on level ground with or without a load. Remark In steep downhill operation, use the decelerator pedal and brake pedal to control machine speed.
2 OPERATING OVER AN OBSTRUCTION When crossing a log or ditch bank, use the decelerator pedal to slow the machine; and when possible, cross at an angle. Then gradually increase the power to the tracks as the machine moves forward, over, and down. If the load is light, it may also be necessary to use the brake pedal. 2 ATTACHING TOWED EQUIPMENT When attaching towed equipment to the drawbar refer to the following steps: A . Use the lowest possible transmission speed. Use the lowest possible engine speed. B . Pull both steering levers rearward to disconnect drive power to the tracks. Use the foot brake to prevent the machine from rolling free. C .
Move both steering levers slowly forward and permit slippage of the steering clutches to inch the machine in the required direction. It is permissible to slip the steering clutches for the purpose of inching or easing the machine movement. Remain clear of the rear area of the machine unless the operator agrees to your presence. You must remain in sight of the operator. When en- gaging the drawbar remain alert and clear of the equipment tongue. Do not insert your fingers into the drawbar pin hole. Failure to exercise ex- treme caution can result in personal injury or death. D . When in position to attach the towed equipment, lift up on the lock cam (1) and secure with the tow pin (2).
2-56 D87E-2 D87P-2