OPERATION 2 SHIFTING THE TRANSMISSION The three speeds of the transmission, controlled by lever (1) and the high and low speed ranges of the steering drive, controlled by levers (2), provide six speeds for both forward and reverse travel. With the steering levers in low range and the transmission shift lever in the (1-2) speed position, the machine can be put into second speed by moving the steer- ing levers into high range. The other four speeds can be obtained in the same manner. It is not necessary to stop the machine when shifting from forward to reverse (or reverse to forward). Shifting can be performed with the machine in motion.
However, it is recommended when shifting in this manner that the engine be decelerated for operator’s comfort. 2 CONVERTER OVERHEATING If the pointer of the torque converter oil temperature gauge moves out of the RUN area of the dial during operation, the transmission may be in a gear range which is too high for the load. Shift down into the next lower gear range. The temperature should reduce; if not, down shift again. If the dial pointer remains out of the RUN range in first gear, stop the ma- chine, shift into neutral and run the engine at 1000 rpm until the gauge pointer moves into the RUN area.
If the converter still remains over- heated, stop the engine and consult your distributor before operating the machine. 2 STEERING THE MACHINE Avoid as much as possible turning the machine on a slope. The machine will tend to slip sideways. Particular care should be taken on soft or clay land. Never make a pivot turn at high speed. Steering is accomplished with the two levers. Each of the levers func- tion in three positions. A (forward) controls the high range, B (middle) controls the low range, and C (rearward) controls the pivot. To make a gradual left turn with the levers in high and pull the left lever into low.
To make a gradual left turn with the levers in low, push the right lever into high. To make gradual right turns, reverse this procedure. To make a pivot turn, first slow down the machine. With the levers in either the high or low, move the lever to C on the side toward which the turn is to be made. When the lever is pulled back slightly from low, a feathering action starts, enabling the operator to make a gradual or full pivot turn; this feathering action continues until the C or pivot is reached. When both levers are pulled simultaneously all the way back, the braking ac- tion stops both tracks. D87E-2 D87P-2 2-55