mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Transmission EAS • An additional travel sensor in the PCA and two switches on the pedal for status detection (pedal folded in/out, pedal fully depressed) ensure the best possible system monitoring and fault detection/diagnosis. • The values of both travel sensors can be accessed on the instrument cluster for diagnosis. • All compressed air connections of the PCA and pressure booster are now connected to the auxiliary consumer circuit. If the pressure in the auxiliary consumer circuit is insufficient (e.g. after an extended idle period), the clutch can still be manually disengaged (with increased applica- tion of force) in order e.g. to perform a cold start.

• To start off in EAS mode, a start-off gear which suits the road surface inclination and vehicle weight is preselected. G26.21-3124-00 Pneumatic actuator (PCA) with connecting housing and dual master cylinder 1) PCA 2) Connecting housing 3) Dual master cylinder 32 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –