mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Distribution Hydraulic components Special hydraulic equipment • Hydraulic system, 1-circuit, 2-cell, fully proportional (code HN2) • Hydraulic system, 2-circuit, 3-cell, fully proportional (code HN4) • Hydraulic system, 2-circuit, 3-cell, fully proportional, snowplow relief (code HN6) • Hydraulic system, 2-circuit, 4-cell, fully proportional (code HN7) • Hydraulic system, 2-circuit, 4-cell, fully proportional, snowplow relief (code HN8) Circuit 1 hydraulic control block G55.00-3163-00 G55.00-3165-00 Rear hydraulic valve Center connections of work hydraulics (circuit II only) The hydraulic connections of circuit II for the center imple- ment mounting space are located on the right side of the vehicle and are always present on vehicles with dual-circuit hydraulics (as of code HN4 to HN8).

These two connections of circuit II (pressure and separate return line) can be used to drive permanent consumers. As at the front of the vehicle, the connection of the pressure line is designed as a male connector and the connection of the return line is designed as a socket. Circuit 2 hydraulic valve block G55.00-3164-00 Introduction of the New Unimog Generation | Model Series 405 41 – This printout will not be recorded by the update service. Status: 03 / 2013 –