Hydraulic components Plug connections Front connections of work hydraulics The front connections of circuit I of the work hydraulics are located within the bumpers (cell 1 and 2 on the left side of the vehicle and cell 3 and 4 and the right side of the vehicle). The pressure connection of circuit II is positioned level with the power take-off stub shaft directly above the right-hand pocket of the front mounting plate viewed in the direction of travel. The separate return line (both for circuit I and circuit II) is located approx. 400 mm to the right (in the direction of travel) from the pressure connection of circuit II.
Right front hydraulic plug connections G55.00-3160-00 Front connections of power hydraulics In addition to the connections of the work hydraulics (circuit I and II), the vehicles can be equipped at the front with the connections of power hydraulics circuit III (code H93) and also with the connections of circuit IV (code H94). The con- nection of the pressure line of code H93 is located at the vehicle front to the left of code H94 (viewed in the direction of travel). G55.00-3161-00 Left front hydraulic plug connections Rear connections of power hydraulics The connections of the power hydraulics are integrated in the platform intermediate frame.
All of the connections are loca- ted at the vehicle rear, above the end crossmember. Special hydraulic equipment at rear • Hydraulic plug connection, rear, 4 connections, cell 1+2 (code H55). Four connections at the rear to cell 1 and cell 2 with hydraulic package, dual action for adjustment operations or continuous oil flow and flat-seal plug con- nections as per ISO 16028 • Pressure line, rear, 2nd hydraulic circuit (code H58). Pres- sure line for circuit II at rear and flat-seal quick-connect coupling, size 19 • Separate return line, rear (code H59).
Separate rear re- turn line for circuit I + II Rear hydraulic plug connections G55.00-3170-00 Rear hydraulic plug connections G55.00-3159-00 40 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –